SUHNER ABRASIVE SH 700 Documentación Técnica página 22

Twist the hand piece to detach it from the grip unit. Twist
the grip piece to detach it from the turnlock fastener. Draw
the grip screw out of the grip piece. Clean the parts thor-
oughly with a brush and detergent. Rinse with water and
let it dry. Do not use aggressive detergent! To connect
the hand piece, follow the above instructions in reverse
order. After connecting, press the grease cup button two
to three times.
4.1.2 r
egrinding the BlAde
The blade can be reground with a com-
mercially available grinding machine.
There are special adapter plates available
for SUHNER blades.
V
ery shArp BlAde
4.1.3 h
Ardening the BlAde
resentative or directly from the manufacturer. Apply the
steel under a light pressure. The last pass should be
along the inside of the blade. When cutting does not im-
prove, the blade must be replaced. Contact the area rep-
resentative or the manufacturer for further information.
O / i
utside edge nside edge
22
!
Exclusively SUHNER steel
must be used. This can be
purchased from the area rep-
When hardening the blade, make sure that you hold the
steel at the correct angle to the blade. When this angle is
too large, the edges of the blade will be rounded off. This
makes regrinding more difficult.
V
ery shArp BlAde
4.1.4 g
reAsing the BlAde
Use only food grade (FDA ap-
proved) lubricants, e.g. TURBO
LUBE
60000078), TURBO LUBE SPRAY (art. no. 60000077).
To fill the grease cup, press in the button. Insert the grease
gun into the nipple on the grease cup, and press strongly
to charge it with grease. Stop when the button has moved
up. Press the grease button at regular intervals and after
cleaning and connecting the hand piece.
!
GREASE (art. no.