Technical Specifications - STEINEL PROFESSIONAL IS 3360 KNX Manual De Instrucciones

For information on making claims under the terms of the warranty, please go to
www�steinel-professional�de/garantie
If you have a warranty claim or would like to ask any question
regarding your product, you are welcome to call us at any time
on our Service Hotline 01733 366700.
10� Technical specifications
IS 3360 KNX
IS 3180 KNX
IS 3360 MX KNX
Dimensions
Surface-mounted installation, round
(L × W × H)
Surface-mounted installation, square
Concealed installation, round
Concealed installation, square
Power supply KNX bus voltage, 21 V - 30 V
Settings via ETS software, remote control or BUS
Sensor system
Angle of 180° with 90° 360° with 180°
coverage angle of
aperture
Reaches Basic IS 3360 KNX
setting 1:
max. 8 - 20 m
tangential;
temperature-
temperature
stabilised
IS 3360 MX KNX
Basic max. 18 m;
setting 2: temperature-
max. 4 - 8 m;
temperature
stabilised
+ precision + precision
adjustment by adjustment
re-positioning using shrouds
the lens and
using shrouds
Switching
448
zones
Twilight setting 2 - 1000 lux, teach
IS 345 KNX IS 345 MX KNX
126 × 65 mm
95 × 95 × 65 mm
124 × 78 mm
94 × 94 × 78 mm
(SELV)
Passive infrared
180° with 45° 180° with 45°
angle of angle of angle of
aperture aperture aperture
max. 20 × 4 m max. 30 × 4 m
max. 20 m (tangential), (radial)
tangential; max. 12 × 4 m mounted at a
(radial); height of 14 m;
stabilised temperature- temperature-
stabilised stabilised
stabilised
+ precision + precision
adjustment
adjustment
using shrouds using shrouds
1416 280
28
Twilight setting,
basic bright-
ness
IP rating
Temperature
zone
Light output
Light 1 – Light 2
Further
outputs
11� Troubleshooting
Malfunction
No power at the sensor
Sensor will not switch
ON
Sensor will not switch
OFF
120
IS 3180 KNX IS 3360 KNX IS 345 KNX
IS 3360 MX KNX
2 - 1000 lux, teach
Surface-mounted: IP54
-20°C to +50°C
Switching, dimming, basic brightness
In-operation telegram
Cause
Break in wiring
Fuse faulty; not switched
ON; break in wiring
Short-circuit
Twilight setting in
night-time mode during
daytime operation
Lamp faulty
Mains switch OFF
Fuse faulty
Detection zone not
correctly adjusted
Continued movement
within the detection zone
Light being operated
is located in the detection
zone and keeps switching
ON as a result of temper-
ature changes
Light being operated is
in the manual override
mode (LED ON)
29
IS 345 MX KNX
Concealed: IP20
Remedy
Check KNX power supply
New fuse, turn ON power
switch, check wiring with
voltage tester
Check connections
Reset
Replace lamp
Switch ON
Replace fuse, check
connection if necessary
Readjust
Check zone and readjust
if necessary or fit shrouds
Adjust detection zone or
fit shrouds
Deactivate manual
override