Electrical Safety - Husqvarna TS350E-02 Manual De Explicaciones

6 Fitting the disc
Disconnect the machine by unplugging
the supply cable.
• Remove the two screw knobs (A) and the pro-
tective case (B) (SEE FIG 9).
The disc locking nut has a left-hand
thread.
!
If the machine is fitted with a brake
motor, do not use the quick-tighte-
ning nut.
• Remove the locking flange (SEE FIG 10).
• Fit the disc.(SEE FIG 11).
Take care about the direction of rota-
!
tion which is shown by an arrow on
one of the faces.
Make sure the contact faces of
flanges, of blade and the axle are
clean.
• Tighten the nut (1) and lock (2)
• Refit the protective case (B).
• Tighten the 2 screw knobs (A) (SEE FIG 13)..
7 Electrical connection

- ELECTRICAL SAFETY :

Operate this machine only on a supply
equipped with a 30 mA earthed cur-
rent-limiting circuit-breaker. Otherwise,
consult our catalogue for appropriate
models.
- The RCCB must be used correctly,
including testing it regularly. For
tools supplied with an integral
RCCB in the cable or in the mains
plug, if the cable or plug has been
damaged, repairs must be carried
out by the manufacturer, one of his
agents or by a qualified repair work-
shop to avoid any risks resulting
from errors.
- Make sure that the mains voltage cor-
responds with that marked on the
=
manufacturer's plate on the machine.
?
- Three-phase motor
Make sure that the motor rotates in the
same direction as the arrow stamped
on the casing: if the motor does not turn
in the direction required, swap two of
the supply wires.
22
- Use the following types of plug, single
phase 2 P + E, or 3xPx+xE /
3xPx+xNx+xE according to the cor-
responding voltage.
- Extension lead: Cable size sufficient for the elec-
trical power, connection to the mains by a H07
RNF type cable of the following size:
- 3 x 2.5 mm up to 50 m for 230 V
2
- 4 or 5 x 1.5 mm up to 100 m for 400 V
2
- 3 x 4 mm 2 up to 40 m for 115 V
8 Starting up
Always pay extreme care and atten-
tion to the preparation of the machine
before starting up
Remove all adjustment tools and
wrenches from floor and machine
Always keep blade guard in place
• Fill the water tank ( level 23 FIG 1 ).
• The water pump starting is coupled with that of
the motor.
As each machine is fitted with a self priming
pump, the water is sprayed onto the disc as
soon as the machine starts.
Ensure that the water supply is abundant,
when cutting wet.
The protective case and the motor mounting
fitted with a deflector blade provide perfect
distribution of the spray.
• To start the machine press the green
button on the switch (optional cut-out
switch).
• To stop the machine, press the red
button.
STOP
phase motor protected by a built-in thermal cir-
cuit breaker.