Installing The Magnet On The Anchor Windlass - MZ electronic NAUTI 030 Instrucciones De Uso

Components
The package contains:
• chain
counter,
fastening kit (2 brackets with
screws) and 3 wire covers of
different colour ;
• magnetic sensor;
• support kit (support for the
vertical shaft anchor windlass
sensor, supporting base, 2
fastening screws, O-ring);
• magnet;
• horizontal
windlass sensor support;
• instructions for use.
Installation

Installing the magnet on the anchor windlass

• A hole having a diameter of 6.5 mm (~1/4") and depth of 8 mm (5/16") must
be drilled on a tooth of the gipsy, in a place outside the chain's path.
• In the case of vertical shaft anchor windlasses (see Fig. 1B), drill the hole in
the lower circumference of the gipsy.
• In the case of horizontal shaft anchor windlasses (see Fig. 2B), drill the hole
in the outer circumference of the gipsy.
• Also make sure that the protruding part of the magnet will not collide with the
base or sensor during rotation of the gipsy.
• Insert the metal part of the magnet in the hole, allowing the protected part to
protrude by about 2 mm. Fix it in place using an adhesive for metals (two-
component epoxy glue) or silicone. The glue used must be able to withstand
a marine environment.
NAUTI 030
gasket,
shaft anchor
16
English
Rev. 05 – 2007