• Secure the instrument in place with the two brackets provided, tightening the
two screws using a cross screwdriver.
• Put the gasket between the front part of the dashboard and the instrument.
• For instructions on making electrical connections, see the attached diagram.
The wires must have a minimum cross section size of 1.5 mm².
• Install a 3 A (ampere) safety fuse on the + wire of the battery.
• The instrument complies with EMC standards (EN55022) and must be
positioned at a distance of 0.5 metres (1.64 Ft) from radio receiver devices.
NAUTI 030
19
English
Rev. 05 – 2007