Assembly; Use - Imetec N1202 Instrucciones De Uso

• Push the silicone rubber plug into the opening at the bottom of the juicing bowl, checking that it is fixed
correctly in place beyond the retainer tooth [Fig. B].
• Place the juicing container on the motor body, making sure the arrow lines up with the one on the
motor body [Fig. C].
• Place the selected filter inside the mixer [Fig. D], aligning the red dot on the filter with the red dot on
the upper edge of the juicing container [Fig. E].
NOTE: if you decide to use the sorbet accessory, this operation must not be performed.
NOTE: if you want to obtain denser and thicker juice, use the wide mesh filter. This filter
does not produce any waste, which is why the extracted juice is denser.
• Insert the auger into the filter by pressing and gently turning completely until a click is heard [Fig. F].
NOTE: the cover cannot be fitted on if the reamer is not completely in position.
• Place the hopper on the juicing container, aligning the red dot on the hopper with the red dot on the
upper edge of the juicing container [Fig. G], then turn it clockwise until completely closed [Fig. H].
WARNING! Comply with the indications in the chapters
"Food contact" and "Quantity and usage time".
WARNING! DO NOT use this appliance if there are visible
signs of damage.
WARNING! DO NOT touch the moving parts.
WARNING! DO NOT use the appliance empty.
WARNING! DO NOT open the lid when the motor is on.
CAUTION! DO NOT slow down or stop the motor by
introducing food in excess in the appliance or by exerting
too much pressure on the presser. If the motor slows down
or stops, switch the appliance off immediately and remove
waste between the lid and the filter. DO NOT exert too much
pressure when making the juice.

ASSEMBLY

USE

EN
22