Adjusting Cutting Depth; Cutting Attachment - Stihl MS 461 R Manual De Instrucciones

Adjusting Cutting Depth

The cutting depth is infinitely adjustable
from just a few millimeters to approx.
8 in (20 cm).
Before each adjustment of the cutting
depth:
Switch off the engine
N
Engage the chain brake by pushing
N
the hand guard (1) toward the nose
of the guide bar – the saw chain is
blocked
Place the chain saw on the ground
N
and position the front of the right
foot in the rear handle
MS 461 R
2
With the right hand, grip the slide
N
from above and loosen the
adjusting screw (2) with the left
hand
Adjust cutting depth (arrow) and
N
tighten adjusting screw (2)
Release the chain brake
N

Cutting Attachment

STIHL is the only manufacturer in the
industry to produce its own chain saws,
guide bars, saw chains and chain
sprockets.
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the chain saw.
1
a
The pitch (t) of the saw chain (1),
–
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
The drive link gauge (2) of the saw
–
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
English
2
3
27