Maintenance; Troubleshooting - Senco XtremePro Serie Instrucciones De Empleo

EN TOOL ELEMENTS
Fine Wire Stapler
FW2
FW1 Magazine Release
FW2 Cap
FW3 Trigger
FW4 Inlet
FW5 Exhaust

MAINTENANCE

Warning
y
Repairs other than those described here should be
performed only by trained, qualified personnel. Contact
SENCO for information at:
+31 320 295 575.
y
Read section titled "Safety Warnings" before maintaining
tool.
y
Only use spare parts specified by manufacturer or autho-
rized representative.
_______________________________________________
y
All screws should be kept tight. Loose screws result in
unsafe operation and parts breakage.
y
Check monthly
_______________________________________________
y
With tool disconnected, make daily inspection to assure
free movement of workpiece contact and trigger. Do not
use tool if workpiece contact or trigger sticks or binds.
_______________________________________________
y
Squirt Senco pneumatic oil (5 to 10 drops) into the air
inlet twice daily (depending on frequency of tool use).
Other oils may damage O-rings and other tool parts.
y
Some Senco tools are Oil Free and DO NOT require oil,
Check label.
_______________________________________________
y
Wipe tool clean daily and inspect for wear. Use non-
flammable cleaning solutions only if necessary.
y
Do Not Soak.
y
Caution: Such solutions may damage O–rings and other
tool parts.
y
Dispose of cleaning materials properly.
Medium Wire Stapler
Bottom Load
FW4
FW5
FW1
MW1
FW3
MW1
MW2
MW3
MW4
MW5
Top Load
MW6
MW3 HW2
MW4
MW5
MW2
Workpiece Contact
Trigger
Exhaust
Inlet
Magazine Release
HW1
HW2
MW6
HW3
HW4
HW5
Feeder Shoe
TROUBLE SHOOTING
SYMPTOM
Air leak near top of tool. / Sluggish operation
1
SOLUTION
Verify air supply / tighten screws or install Repair
Kit – See Parts Manual
SYMPTOM
Air leak near bottom of tool / Poor return.
2
SOLUTION
Clean tool / tighten screws or install Repair Kit
See Parts Manual
SYMPTOM
Other problems.
3
SOLUTION
Contact SENCO.
8
Heavy Wire Stapler
HW3
HW1
NS20XP
CONSTRUCTION STAPLES
/ " (11mm) 1" (25mm) – 2" (50mm)
7
16
Workpiece Contact
Exhaust
Trigger
Feeder Shoe
Inlet
Should Staple Jam Occur:
Disconnect Air Supply
Remove Fasteners
Clear the Jam
Follow loading Procedure
HW5
HW4