Mounting Locations; Remote; Standard Mount - Rockford Fosgate RAV Serie Instalación Y Operación

I
NSTALLATION

MOUNTING LOCATIONS

The mounting position of your source unit will have a great effect on the performance of your in-
dash CD/DVD Player. The source unit can be installed in a wide range of operating locations.
However, care should be taken to ensure optimum performance.
Engine Compartment
Never mount this unit in the engine compartment. Mounting the unit in the engine compartment
will void your warranty.
Instrument Panel
Mounting the source unit in the instrument panel provides optimum access. The source unit should
be securely mounted using the "Standard Mount" or "ISO-DIN Mount" method to ensure optimum
CD/DVD Player performance.
Center Console
Mounting the source unit in the center console provides optimum access. Be sure the installation
does not interfere with the operation of the gear shift or parking brake.
Glove Box
Mounting the source unit in the glove box is adequate, but does not provide easy access. Glove box
mounting should only be done if "Instrument Panel" or "Center Console," mounting is not
acceptable (i.e., maintaining integrity of older vehicles with metal dashboards.)
Under Dash
Mounting the source unit under the dash is adequate, but does not provide easy access. Under dash
mounting should only be done if "Instrument Panel," "Center Console" or "Glove Box" mounting is
not acceptable. Mount the source unit off to the side of the driver's area to reduce interference with
the parking brake, gear shift, or operating pedals.
NOTE: The source unit should have a mounting angle within ±20° from horizontal.

REMOTE

Install the clip mount for the remote using two (2) screws or double-sided tape in a location that
allows easy access.
CAUTION: To prevent accidents, never place the remote where it will impair the
!
safe operation of a vehicle.
Battery Installation
1. Remove the battery cover on the back of the remote.
2 Install two (2) AAA batteries with the polarities correct as shown by the diagram inside the
battery compartment of the remote.

STANDARD MOUNT

Installing;
• Mount the Locks for the Installation Sleeve
onto the source unit (use supplied screws).
• Mount the Installation Sleeve into a secure
instrument panel.
NOTE: Make sure to mount the Source Unit as
close to horizontal as possible for
optimum CD/DVD Player performance.
Mounting Angles of up to ±20˚ from
horizontal can be accommodated.
6
Sleeve
Screw
Back Strap
Dash
Trim
+ 2
0 °
H o
r i z
o n
t a l
Lock
- 2 0
°