Regular Maintenance - Rock Shox Judy C Manual Del Propietário

Before every ride, inspect the following parts:
1. Front wheel and quick release for proper installation and adjustment
2. Fork for any obvious damage (crown, brace, upper tubes, lower tubes, and dropouts)
3. Front brake cable for proper routing
4. Front brake pads for proper contact with the rim
5. Front brake lever for proper adjustment
6. Headset for proper function and adjustment
After every ride clean and dry the fork, taking care not to get water in the fork at the upper tube/lower tube
junction.
After every week or eight hours of riding, clean and oil the upper tubes and check fasteners for proper torque.
Follow this procedure:
1. Lift fork boots from lower tubes. Then wipe exterior surfaces, Resi-wiper seal
area and upper tube clean. Apply 2-3 drops of Teflon-fortified oil to the
upper tubes at the Resi-wiper. (See Fig. 5)
2. Refit fork boots into Resi-wiper seal groove using small blade screwdriver.
Engage the boot with Resi-wiper seal groove at the rear and rotate boot
around the upper tube to fully engage its lower edge behind the brace. A
small amount of oil on the mating surfaces helps.
3. Check crown bolts, brace bolts, and brake posts for proper torque. (Refer to Torque Tightening Values, above.)
4. Repeat procedure on other leg.
A
FTER EVERY YEAR OR ONE HUNDRED HOURS OF RIDING
After every year or one hundred hours of riding, clean and grease the spring stacks, bushings, Resi-wiper seal and
replace the oil.
T
O CLEAN AND GREASE THE SPRING STACKS
1. Mount the bike in a stand, disconnect the front brake cable, and remove the front wheel (the brakes do
not need to be removed).
2. Place an oil pan beneath the lower legs of the fork.
3. Unscrew the top cap using 24mm wrench or socket wrench.
4. Remove the spring stack assembly and clean the stack with degreaser. Wipe dry.
5. Inspect spring for compression set (see "Spring Specification" table, page
14.) Replace as needed.
6. Partially loosen shaft bolts with a 5mm hex wrench, tap bolts firmly with a
mallet breaking shafts free from lower tube (see Fig. 6) , and remove bolts
completely. Oil from the Hydracoil/free valve system will pour out of the
P 12
AGE

Regular Maintenance

B
EFORE EVERY RIDE
A
FTER EVERY WEEK OR
,
BUSHINGS AND
E
IGHT HOURS OF RIDING
R -
ESI WIPER SEAL
Fig. 5
,
FOLLOW THIS PROCEDURE
Fig. 6
PN 950-001770-01, R
:
B
EV