Rock Shox Judy C Manual Del Propietário página 8

8. Judy XC Bolt-Type Crowns: When installing or servicing this fork, verify the crown shims and
crown slots of the upper tube clamps are free of debris or other material to insure proper performance.
When tightening the crown bolts, be sure that one crown shim is located between the slot of each upper
tube clamp. Torque the lower crown bolts to 90 in-lb (10 Nm).
I :
MPORTANT THE CROWN SHIMS MUST BE USED WITH THE JUDY BOLT
INSTRUCTIONS MAY RESULT IN ADDED STRESS TO THE UPPER TUBES
BICYCLE WITH POSSIBLE SERIOUS AND
9. Hangerless Reflector Bracket Installation: Orient black reflector bracket to the front of the
fork with the 90 degree bend under the fork brace. Place the .040" thick flat washers onto the hex bolt
and insert this assembly through the lowest oval hole in the bracket and through hole in brace. Place
star washer and thread nut onto bolt at back of brace. Torque to 60 in-lb. (6.8Nm).
Hangered Reflector Bracket Installation: Orient the black reflector bracket with the hook
of the bracket facing up and to the fork brace. Place the star washer onto the hex bolt and insert the
bolt, with star washer, through the rear hole on the hook of the bracket. Thread the bolt through the
hole on fork brace. Torque to 20in-lb. (2.3Nm).
1. Remove the existing fork and lower
headset race from the bicycle.
2. Before you install a Judy XLC on the
bicycle, verify that the fork has been
supplied with the correct upper crown.
Refer to Fig. 2 for upper crowns
available for Judy XLC and to maximize
fork stiffness by proper selection and
orientation of the upper crown.
3. The steerer tube may need cutting to
proper length. To cut the steerer tube,
removal of the upper tubes are required.
This is necessary otherwise the upper
tubes will be in the way when cutting
the steerer tube to proper length. The
steerer tube length is determined by the
following parts: Judy XLC upper crown
steerer clamp length, stem steerer tube
clamp length, frame head tube length
and top and bottom headset stack
height (see Fig. 3). To ease in the
assembly, do not install the Judy XLC
upper crown on to the upper tubes until
the steerer has been cut to the proper
length and the lower crown has been
fastened in the required position. HINT:
MEASURE TWICE AND CUT ONCE!
I : D
MPORTANT O NOT ADD THREADS TO
R S .
OCK HOX STEERERS
CROWN ASSEMBLY IS A ONE
R
EPLACEMENT OF THE ASSEMBLY MUST BE
P 8
AGE
/
OR FATAL INJURIES
Judy XLC Installation Instructions
T
HE STEERER TUBE
- .
TIME PRESS FIT
-
TYPE CROWN
,
RESULTING IN LOSS OF CONTROL OF THE
.
Short Upper Crown, Inverted
< 136mm
Tall Upper Crown
156mm –
172mm
Fig. 2
Fig. 3
PN 950-001770-01, R
. F
AILURE TO FOLLOW THESE
Short Upper Crown
136mm –
156mm
Extra Tall Upper Crown
172mm –
195mm
B
EV