Kleenmaid HALFFRAME90 Instrucciones De Uso Y Detalles De La Garantía página 11

INSTRUCTION ON MOUNTING AND USE
GB
Cleaning
The cooker hood should be cleaned regularly internally and externally.
For cleaning use a cloth moistened with denatured alcohol or neutral
liquid detergents. Avoid abrasive detergents.
Warning:
Failure to carry out the basic standards of the cleaning of the cooker
hood and replacement of the filters may cause fire risks.
Therefore we recommend oserving these instructions.
Maintenance
Prior to any maintenance operation ensure that the cooker hood is
disconnected from the power supply.
Grease filter
This must be cleaned once a month (and, for the model with
electronic control panel, every time LED 4 starts to flash –
see preceding page) using non aggressive detergents,
either by hand or in the dish-washer, which must be set to
a low temperature and a short cycle.
When washed in a dish-washer, the grease filter may
discolour slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle
(f) - (Fig. 2).
Only for model with electronic control panel:
Once the grease filters have been cleaned, press button 1 (see
preceding page) for about 3 seconds until you hear the acoustic
signal (beep): the LED 4 will now stop flashing.
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
(when using the hood 2,5 hours per day, in avarage and,
for the model with electronic control panel, every time LED
5 starts to flash – see preceding page) using hot water and
a suitable detergent, or in a dish-washer at 65°C (if the dish-
washer is used, select the full cycle function and leave
dishes out).
Eliminate excess water without damaging the filter, then remove the
mattress located inside the plastic frame and put it in the oven for 10
minutes at 100° C to dry completely. Replace the mattress every 3
years and when the cloth is damaged.
Remove the filter holder frame by turning the knobs (g) 90°
that affix the chimney to the cooker hood (Fig. 3).
Insert the pad (i) of activated carbon into the frame (h) and fit the
whole back into its housing (j).
Only for model with electronic control panel:
Once you have replaced the charcoal filter, press button 1 (see
preceding page) for about 3 seconds until you hear the
acoustic signal (beep).
LED 5 will now stop flashing.
Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this manual. All responsibility,
for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined.
Replacing lamps - Fig. 4
Access the light compartment – according to the model
in your possession, proceed as follows:
extract the guard by levering it off with a small screwdriver or similar
tool (fig. 4.1)
or
press on the lamp cover and release to open (fig. 4.2).
Replace the damaged light bulb.
Only use halogen bulbs of 20W max (G4), making sure you do not
touch them with your hands.
Close the lamp cover (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
Caution
This appliance is designed to be operated by adults. Children should
not be allowed to tamper with the controls or play with the appliance.
Do not use the cooker hood where the grill is not correctly fixed! The
suctioned air must not be conveyed in the same channel used for
fumes discharged by appliances powered by other than electricity.
The environment must always be adequately aerated when the
cooker hood and other appliances powered by other than electricity
are used at the same time. Flambé cooking with a cooker hood is
prohibited. The use of a free flame is damaging to the filters and may
cause fire accidents, therefore free flame cooking must be avoided.
Frying of foods must be kept under close control in order to avoid
overheated oil catching fire. Carry out fumes discharging in
accordance with the regulations in force by local laws for safety and
technical restrictions.