Klippan kiss Manual De Instrucciones página 21

Fitting instruction – Fitting using a two-point belt
27. Prepare the base as shown in illustration 19 and 20. Extend the belt to its full length, then click it into its usual lock. Pull the
belt under the frame.
28. Thread the belt through the blue mounts on both sides.
29. Push down the base, tensioning the belt at the same time. Make sure that the belt is tensioned and holds the base firmly in
position
30. Adjust the height of the supporting leg by pulling out the red button. Make sure that it sits firmly on the floor. The supporting
leg must be adjusted so that the base rests on the seat. Move on to fitting of the seat itself, illustration 31
Fitting instruction – Fitting the seat
31. Raise the head protector to its upper position
32. Pull up the handles on both sides.
33. Put the handles together by bending them down towards the centre and clicking them into one another
34. Position the seat as shown in the illustration. Then turn back 90˚
35. Put seat on top of the base. Thread red triangle marked "G" towards track of base.
36. Please note indicator (A) is currently red. Now, push down seat into base...
37. ... Put seat in position "1". Listen for an audible "click". Indicator should now show green (A).
38. NOTE!!! CHECK THOROUGHLY THAT SEAT HAS LOCKED INTO BASE IT SHOULD NOT BE POSSIBLE TO LIFT THE SEAT FROM
THE BASE.
39. Push the head protector down against the seat. Adjust the seat angle using the handle on the front of the seat (see
illustration 1)
40. The tilt position is adjusted easily using the handle of the front of the seat, see illustration 1. Tilt position 1 is for new-borns.
Position 2 and 3 are for children over 9kg.
41. Always make sure that the safety indicator is fully green (A). Never use the seat if you are unsure about how it is fitted, In
this case , contact your nearest dealer.
42. Make sure that the child is securely fastened in the seat. The internal straps must be tightened properly about the child.
Getting a few adult fingers between the straps and the child is good and safe.
Remember: An incorrectly fitted seat could endanger the life of your child in the event of a collision.
Comfort
43. When the baby protector is lifted out of its base and placed on the ground, it can be used as a soothing rocker. The rocking
function can be prevented as shown in the illustration. Remember to unlock the rocker lock before returning the seat to the
base.
44. Push-handle and wheels are standard. These equipment will allow you to transport your child for short distances in the seat.
Good for mothers who have had Caesarean sections!
45. Sunshade. Protect that little head from the heat and the burning sun. (Accessory)
21