Using The Headset - Impecca HSB100 Manual Del Usuario

Pair and connect the headset with a music player
If your phone does not support the A2DP Bluetooth profile, you can separately pair the headset with
the phone and a music player that supports this Bluetooth profile.
If you have paired and connected the headset with your phone, disconnect the headset from it before
pairing the headset with a music player. To pair the headset with a music player, follow the instructions
in the section above. If your music player does not have a keypad, it may use the Bluetooth passcode
" 0000 " by default. Refer to the user's guide of your music player for further instruction.
Disconnect the headset
To disconnect the headset from your device, switch off the headset, or disconnect it in the Bluetooth
menu of your device. You do not need to delete pairing with the headset to disconnect it.
Reconnect the headset
To connect the headset to the phone or music player that you have last used with it, switch on the
headset, or make the connection in the Bluetooth menu of your device. In your device, you may be able
to allow the headset to connect to it automatically whenever the headset is switched on. For further
instructions, refer to your device's user's guide.

USING THE HEADSET

Place the headset over your ears so that the pad indicated with L is on the left ear and the pad with R is on
the right ear. Adjust the length of the headband until the speaker pads rest comfortably on your ears.
Warning:
Adjust the volume
To adjust the headset volume, press the volume up button to increase or the volume down button to
decrease the volume during a call or while listening to music.
Call handling

To make a call, while connected to the headset, use your mobile phone and dial as you normally
would.
 To answer a call, press the multifunction button or use the keys on the phone.

To reject the call, press and hold the multifunction button for about 5 seconds.

To end a call, press the multifunction button or use the keys on the phone.
Listen to music
To listen to music, connect the headset to a compatible music player such as a mobile phone with a
music player feature or other music device and then press the multifunction button. The music player
must support the A2DP Bluetooth profile. The music functions available depend on your music player.
Note: If you receive or make a call while listening to music, the music is paused until you end the call.
To pause or resume playing, press the multifunction button. To stop playing music, press and hold the
multifunction button for about 2 seconds.
When using the headset your ability to hear external sounds may be affected.
Do not use the headset in areas where your safety is in danger.
- 6 -