Craftsman 152.229000 Manual Del Usuario página 14

Figure 4-4 DRILL PRESS HEAD AND
MOTOR ASSEMBLY
O
K
* The ddH press is a heavy machine; two peopb may
be required for certain assemMy operations,
* MAKE CERTAIN the ddH press is disconnected from
the power source,
Figure 5-1
A
4,
Assembb the threaded end of the tame rotation
bck handb (L) into hoUe(M) in the front, right side
of the tame support, Do not compbteUy tight handb
at this time, Note: The tame rotation bck handb
is the smaller of the two bck handbs,
See Figure 4-4,
Figure 4-5
N
B
1, Seat the ddH press head (A) on the coUumn (B),
See Figure 5-1
Figure 5-2
D
K
5,
insert the tame (N) into the mounting hole (0) table
support (K), Rotate the table to desired position
and tighten table rotation locking handle, See
Figure 4-4 and 4-5,
2, Align the drill press head with the table and base,
Tighten the two head locking screws (C), See
Figure 5-2
3, Thread the three pinion shaft handles (D) in the
three tapped hobs located in the pinion shaft (E),
14