Rear Panel; Connecting Speakers - Work Pro PA 100 Manual De Uso

REAR PANEL

6. AC IN connector
Connect the supplied power cord.
Caution
·When connecting the power cord, connect the power cord to the connector and then plug
it into an appropriate AC power outlet.
·Before connecting or disconnecting the power cord, make sure that the power to the
device is turned off.
[SPEAKERS] output terminals
7.
Barrier strip type speaker output connectors. Refer to "Connecting Speakers" for
the installation instructions.
[SETUP]
8.
Allows to set some functions (only operates DIP number 4)
9. [OUTPUT]
Sets the output type of amplifier: high-impedance connection ([100V], [70V]) or
low-impedance connection ([8Ω 16Ω]).
10. [RS485 input (RJ45 connection)]
It is possible to send RS485 commands from an external device in order to control
several function in PA 100.
11. [LINE IN]
RCA type stereo input jack (unbalanced. Connect external devices such as
CD player, etc.

CONNECTING SPEAKERS

Change the setting depending on the speaker connection (high- or low-impedance
connection).
CAUTION
·Before connecting speakers, make sure that the power of the device is turned off.
If the power is on, there is a risk of electrical shock.
·In a high-impedance installation, make sure that the sum of the power input
ratings of the speakers to be connected does not exceed 100W.
·In a low-impedance installation, make sure that the total impedance of speakers
to be connected is at least 8 ohms.
6
DIP switches
switch
PAGE 4
7 10
11
L
R
8 9
User Manual / Manual de uso
EN
PA 100