Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
MI+
E PRESET on the remote control
The function is the same as that of + F on the main unit.
If the remote control is not going to be used for an extended
period of time, remove the batteries
to prevent possible
electrolyte leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
POWER
ECO
-l-El
Ii
I
ENTER
L-
!.
,!,
,..
)'
0--0/:
-.
'". —
m
Q Q
OL30
/ @
MULTI JOG
~-.
---
/u
To turn the power on
Press one of the function buttons (TAPE DECK1/2, TUNER
BAND, VIDEO/AUX, CD, MD). Playback of the inserted disc or
tape begins, or the previously tuned station is received (Direct
Play Function).
POWER is also available.
When the power is turned on, the disc compartment may open
and close to reset the unit.
To turn the power off
Press POWER.
To change the brightness
level of the display
1
2
3
Press ECO so th;t "ECO MODE is displayed. -
Within 4 seconds, turn MULTI JOG to display "DIM MODE,
and then press ENTER within 4 seconds.
Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
The mode will be automatically set after 4 seconds. It will also
be set if ENTER is pressed within 4 seconds after step 3.
DIM-OFF *DIMMER
1 +
DIMMER 2*
DIMMER 3
DIM-OFF: The normal display.
DIMMER
1:
The illumination of the display is dimmer than
usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3: The illumination of the display is dimmer than
DIMMER 2. The spectrum analyzer, and the button lamps light
off .
m
If the timer recording (page 27) is done with the economizing
mode (page7) set to "ON" and the power turns off, the dimmer
mode will be set to "DIMMER 3 the next time the power is
turned on,
6
ENGLISH
Publicidad
Tabla de contenido
