Required accessories and tools
Supplied accessories
–
Installation manual
–
Operating instructions
–
Installation accessories
Optional accessories
Extreme Combination Side-by-Side Heating kit
If the gap between the appliances is less than 6"
(160 mm).
Panel unification part (Metal strip)
For connection of two furniture doors (see explanation in
Section "C/4. Preparing the furniture doors"). Can be
used for standard height furniture doors without further
preliminary work.
Other required accessories from
specialist outlets
Ice maker installation kit
For connecting appliances which require water,
e.g. for an ice maker.
Maximum outer diameter of the water pipe
3
(without fittings):
/
" (9.5 mm).
8
Miscellaneous
–
Step ladder
–
Trolley, wheelbarrow or sack barrow
–
Hammer drill for drilling holes into the wall and floor
–
Various size drills for various materials
–
Wooden beam (cross section min. 3" x 4") as an
alternative tip protection, length according to the
width of the installation niche
–
Various size wood screws
1
–
Thin (max.
/
" (1.5 mm)), material suitable for
16
protecting the floor against damage (e.g. linoleum)
–
Suitable material for covering and protecting
furniture (e.g. protective sheets)
–
Adhesive tape
Note:
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
1
/
" OD copper line
4
Tools
Cordless screwdriver
T20 Torx-bit magnetic
holder
T20 Torx screwdriver
5
/
" (8 mm) socket
16
wrench
Various size drills
1
Open end wrench
/
"
2
(SW 13 mm)
Multigrip pliers
Adjustable wrench
Cutter with adjustable
blade
Metal tape measure,
folding ruler
Square
2' (60 cm) and 4' (1 ,2 m)
spirit levels
Level, min. 4' (1 ,2 m) long
9