Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario página 18

13
Tools Needed:
Place the top section in the opening
and vertically align with lower sections.
Hammer
Temporarily secure the top section by
driving a nail in the header near the
center of the door and bending it over the
top section. Now fl ip up hinge leaf, hold
tight against section, and fasten center
hinges fi rst, and end hinges last. (Refer
to Step 8). When installing a door with a
TorqueMaster
vertical track alignment is critical.
Position fl agangle between 1-11/16" (43
mm) to 1-3/4" (44 mm) from the edge
of the door. Flagangles must be parallel
to the door sections. Now complete the
vertical track installation by securing the
center jamb bracket and tightening the
other lag screws. Repeat for other side.
IMPORTANT: THE DIMENSION BETWEEN
THE FLAGANGLES MUST BE DOOR-
WIDTH PLUS 3-3/8" (86 MM) TO 3-1/2"
(89 MM) FOR SMOOTH, SAFE DOOR
OPERATION.
14
Attaching Quick Install Flagangle
NOTE: If you have fully adjustable fl agangle,
Tools Needed:
skip this step and complete Step 15.
9/16" Socket
To install horizontal track, place the curved
end over the top roller. Align key slot of the
Ratchet Wrench
horizontal track with the quick install tab
of the fl agangle. Push curved portion of
9/16" Wrench
horizontal track down to lock in place.
Level
WARNING
DO NOT RAISE DOOR UNTIL HORIZONTAL
TRACKS ARE SE CURED AT REAR, AS
OUTLINED IN STEP 34, OR DOOR COULD
FALL FROM OVERHEAD POSI TION CAUSING
SEVERE OR FATAL INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in the
fl agangle using (1) 3/8" - 16 x 3/4" truss
head bolt and (1) 3/8" - 16 hex nut. Repeat
for other side. Remove the nail that was
temporarily holding the top section in place,
installed in Step 13.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
NOTE: If an
position horizontal tracks slightly above level.
NOTE: After completing this step, continue
with Step 16.
18
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Top Section
® counterbalance system,
to Horizontal Track
® opener will be installed,
idrive
NAIL
FLAGANGLE
KEY
SLOT
HORIZONTAL
TRACK
QUICK
INSTALL
TAB
VERTICAL
TRACK
3/8" - 16 X 3/4"
TRUSS HEAD BOLT
DOOR WIDTH
+3-3/8" TO 3-1/2"
1-11/16"
TO 1-3/4"
TOP
SECTION
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
KEY SLOT
VERTICAL
TRACK
3/8" - 16 HEX NUT
HORIZONTAL ANGLE
HORIZONTAL TRACK