Package Contents - Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario

Package Contents

(2) TOP BRACKET SLIDE
(2) FULLY ADJUSTABLE RH/LH
FLAGANGLE (AS REQUIRED)
ASYMMETRICAL U-BAR
(IF INCLUDED) (IF INCLUDED)
RIGHT & LEFT Q.I. JAMB BRACKETS
DRUM WRAPS
(AS REQUIRED)
RIGHT & LEFT 36 TOOTH WORM GEAR
END BRACKETS (AS REQUIRED)
9100, 9600, 5120, 5140
TorqueMaster ® - Single and Double Spring
Installation Instructions and Owner's Manual
IMPORTANT NOTICE!
Read these instructions carefully before
attempting installation. If in question about
any of the procedures, do not perform the
work. Instead, have a qualifi ed door agency
do the installation or repairs.
© Copyright 2005 Wayne-Dalton Corp. Part No. 302868 Rev. 2 08/04/2005
MANUAL STUD PLATE
(IF INCLUDED)
(2) 3/8"- 16 HEX NUT 5/16" X 1 5/8" HEX HEAD LAG SCREW
(4) 1/4"-20 X 9/16" LARGE
HEAD RIBBED TRACK BOLTS
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
NOTE: DEPENDING ON THE DOOR MODEL, SOME PARTS LISTED WILL NOT BE SUPPLIED IF NOT
NECESSARY. REAR SUPPORTS MAY OR MAY NOT BE INCLUDED WITH YOUR DOOR.
(2) QUICK INSTALL RH/LH
FLAGANGLE (AS REQUIRED)
U-BAR IDRIVE ® OPERATOR
(SOLD SEPARATELY)
(1) OPERATOR BRACKET
COUNTER COVERS
(AS REQUIRED)
LUBRICATING OIL PULL ROPE
(AS REQUIRED)
(IF INCLUDED)
(AS REQUIRED)
(4) 1/4"-20 X 5/8"
1/4"-14 X 5/8" SELF TAPPING
CARRIAGE BOLTS
DOOR SECTIONS (AS REQUIRED)
(1)TORQUEMASTER
(2) HORIZONTAL TRACK RH/LH
(2) HORIZONTAL ANGLE
(21-15/16" OR 80")
(AS REQUIRED)
(2) TOP BRACKET BASE
COUNTER GEAR
(AS REQUIRED)
(1) LOOSE WINDING SHAFT
(SINGLE SPRING ONLY)
3/8"- 16 X 3/4" HEX HEAD (2) 3/8"-16 X 3/4"
BOLT (IF INCLUDED) TRUSS HEAD BOLT
SCREW (AS REQUIRED)
®
SPRING TUBE
RIGHT AND LEFT CABLE
DRUM ASSEMBLIES
WEATHER SEAL & NAILS
(IF INCLUDED)
ROLLERS (1) CENTER BRACKET
(AS REQUIRED)
(1) 3/8" - 16 NYLOCK 1/4"- 20 FLANGED HEX
NUT (IF INCLUDED) NUT (AS REQUIRED)
1/4"-20 X 11/16" SELF DRILLING
SCREW (AS REQUIRED)
(2) #12 X 1/2" PHILLIPS (2) #10 PHILLIPS
HEAD SCREWS HEAD SCREWS
(2) VERTICAL
TRACK RH/LH
ASSEMBLY
3