Step Plate; Pull Rope - Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario

❉
Make one mark 1" (25 mm) up from
Tools Needed:
the center of bottom edge of the bottom
7/16" Drill Bit
section and another mark 2-3/16" (56 mm)
up from the fi rst mark.
Power Drill
7/16" Wrench
Drill a 7/16" (11 mm) hole through the
section at each mark and insert the outside

step plate.

Loosely fasten step plate slide to base with
(1) 1/4" - 20 x 5/8" carriage bolt and nut.
Align inside step plate holes and fasten
from inside using the #8 screws provided.
Install one #8 x 3/4" screw in the bottom
step plate hole. The screw in the top hole
varies with door models.
Use the screw size shown below for your
model door.
a) #8 x 3/4" screw for Model 9100
b) #8 x 1" screw Model 9400/9600
Tighten 1/4" - 20 carriage bolt and nut.
❉
WARNING
Tools Needed:
DO NOT INSTALL PULL ROPES
Power Drill
ON DOORS WITH ELECTRIC
1/8" Drill Bit
OPERATORS. CHILDREN MAY
BECOME ENTANGLED IN THE
ROPE CAUSING SEVERE OR
FATAL INJURY.
Measure and mark the jamb
approximately 48" to 50" (1220 to 1270
mm) from floor on the right or left side
of jamb. Drill 1/8" pilot hole for No. 6
screw eye. Tie the pull rope to the No.
6 screw eye and to the bottom bracket
as shown.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Step Plate
1/4" - 20 X 5/8"
CARRIAGE BOLT
NO. 6 SCEW EYE

Pull Rope

STEP PLATE OUTSIDE
STEP PLATE
BASE
STEP PLATE
SLIDE HEX NUT
PULL ROPE
PULL ROPE
STEP PLATE INSIDE
ASSEMBLED
(2) #8 SCREWS
STEP PLATE
BOTTOM BRACKET
33