Transportation Requirements - BALAY 3XM4H Serie Instrucciones De Uso

Cleaning and Maintenance
Press the "+" and the "–" key at the same
time to make the symbol
from the screen after changing the filter.
The symbol disappears from the screen
and the filter is operational again.
Fitting the purifying filter (double
active):
• Check that the purifying filter is fitted in
the positioner. If it is not, fit as shown on
Fig 21 Place the dark part of the filter in
contact with the positioner.
Fig. 21
• Remove the basic filter from the
appliance, Fig. 20.
• Insert the double active filter + positioner
in the basic filter as shown on Fig. 22,
remembering that it must be housed on
the lower studs first.
cl ack!
2
cl ack!
Fig. 22
• Install the assembly onto the appliance
by lining the lower studs up with the
slots on the front casing of the appliance
and pressing the top clip in until it clicks
into position. The assembly is fitted
properly when it clicks into position.
• Close the front flap.
Warning!
Fit only one set of filters onto the
support in order to ensure correct
appliance operation.
disappear
1
65
Note:
The flaps on these models are fitted
with safety stops up to which point they
can be opened without risk of the front
flap falling and causing damage and/or
injury.
The flap can also be removed in order
to clean the appliance or change the
filters more easily. When removing the
flap or in the event of the flap coming
out of position for whatever reason, the
user should fit the plastic leg on the
flap into the groove on the front of the
appliance until it is properly rehoused.
After refitting, make sure that the flap
stops when its reaches the safety stop
and does not fall.

Transportation requirements

The appliance is fitted with wheels to
make it easier to move around. It can be
tilted, if necessary, in order to make
transportation easier. You should not turn
the appliance back on again for a
minimum period of one hour after
performing this procedure.
Before tilting it, empty the condensed
water from the internal tank by
extracting the water drainage pipe from
its housing and removing the plug, Fig.
23. Place a receptacle (or the
appliance's removable tank) at the
end of the water drainage pipe to
collect the condensed water or lead
the pipe to the nearest drain. Do not
forget to replace the plug and reinsert
the pipe in its housing when the tank is
empty.
Fig. 23