User Guide; Cleaning And Maintenance - Evomove nomi Baby Guía De Usuario

User Guide

IMPORTANT! READ AND FOLLOW
THE INSTRUCTIONS CAREFULLY AND
SAVE THEM FOR FUTURE REFERENCE.
Congratulations with your new Nomi Baby de-
veloped for the needs of your infant. Nomi Baby
is approved for children up to 9 kg.
Assembling Nomi Baby
Start by mounting the two legs of the chair as
instructed in the user guide (fig. 1, p. 29) (seat,
back and footrest are to be stored and fitted
instead of Nomi Baby when your child can sit
unaided). Use the supplied Allen keys and
assembly on a level surface. The Allen keys
are located under the footrest. Then mount
Nomi Baby on the stem as shown (fig. 1, p.
29). Important! Always use the TufLok® coated
screws (TufLok® provides a firmer grip and the
screw do not need to be tightened so often)
that comes with Nomi – the screws are hard
to tighten and you have to use both Allen keys
when mounting the legs. Keep counter with one
Allen key and tighten with the other. See also
the assembly video at www.evomove.com.
Adjusting Nomi Baby
By loosening and tightening the handle under
Nomi Baby, you can adjust it seamlessly from
almost horizontal to more upright positions, to
meet your child's needs.
The harness
The harness can be used as a 3- and 5-point
harness. While the child is very small, the
shoulder straps can be removed (fig. 4c, p. 30)
or hidden under the mattress. When your child
begin to lift its upper body, use of the shoulder
straps is recommended. The entire harness can
be removed and washed (fig. 3, p. 30).
Installing and washing textiles
and harness
The mattress and harness are installed by plac-
ing the mattress and harness on the base (fig.
2, p. 30). Pull the straps of the harness through
3
the mattress and base and fasten it 5 places in
the frame (fig. 3a-d, p. 30). This is made easier
by pulling the loop sideways through the open-
ings in the frame (fig. 3a+b, p. 30). Pull the loop
all the way through and check that the harness
is placed correctly. Then pull the mattress
around the edge and tighten the cord using the
cord stopper and tying a knot (fig. 4A+B, p. 30).
The mattress is reversible and washable. When
washing the mattress, open the harness in five
parts, pull shoulder and side straps through the
mattress and only remove the crotch strap in
the frame.
The base, too, can be removed and washed.
Remove the harness by pulling the loop side-
ways out of the openings in the frame. Loosen
the Velcro fastener in the foot end of the base
and remove one side at a time by pulling the
plastic bands out of the groove. Re-install by
putting the plastic bands in the groove one side
at a time. Pull down firmly at the bottom and
close the Velcro ties again. Then re-install the
mattress and harness. Do not tumble dry the
base.

Cleaning and maintenance

The chair must be cleaned with a damp, soft
cloth with a standard mild detergent such as
dish soap. The chair does not tolerate strong
detergents or solvents. Strongly staining foods
(such as curry and ketchup) may discolour the
plastic. Any black lines may be removed with a
white pencil eraser. Be aware that the colours
of the chair may fade over time if the chair is
placed in direct sunlight.
Made with care
Plastic parts are FIRA-tested and made of poly-
propylene and wood meets the FSC standard.
Textiles comply with Oeko-Tex® standard 100.