FAAC E145 Guia De Incio Rapido página 16

Display Advanced Function
Ad
ADMAP FUNCTION
EC
ANTI-CRUSHING SENSITIVITY (only displayed with the
Varying this function alters the time after which the board commands the
leaves to reverse their direction in case of an obstacle or to stop if they are
in the contact point search space (refer to the
The fourth consecutive obstacle detected in the same direction and position
will be defined as a contact point and the leaf will stop in this position.
00
= minimum sensitivity (maximum time before reversal)
10
= maximum sensitivity (minimum time before reversal)
r8
MECHANICAL STOP SEARCH ANGLE (only displayed with the
function and
The mechanical stop search angle within which the board stops the movement without
reversing if an obstacle is encountered or the mechanical stop itself can be adjusted.
Can be adjusted from
0.1 degree steps apply when adjusting between
1 degree steps apply when adjusting between
tA
ADDITIONAL OPERATING TIME
Fc FA
and
OUT 1:
o1
00
Default
t1
OUT 1 TIMING
OUT 2:
o2
02
Default
t2
OUT 2 TIMING
Adjustable like
MAINTENANCE REQUEST - CYCLE COUNTER
AS
2 functions)
nc
CYCLE PROGRAMMING (THOUSANDS)
nd
CYCLE PROGRAMMING (TENS)
STATUS OF THE AUTOMATED SYSTEM:
St
ST
Refer to
E145
Fc FA no
and =
0.3 20
to
no 02
= or functions)
= always active. Output can be configured from
(only displayed with the
= LED - Refer to the options in
(only displayed with the
t1
.
Basic Function.
En
rB
function).
02
or = functions):
degrees.
0.3
and
10 20
and
only displayed with the
o1 03 o1
= or
o1
.
o2 03 o2
= or
(linked to the subsequent
7
Default
no
Y 05
= function):
En Y 4.0
=
9.9
degrees.
degrees.
En no 03
= and
00
00 17
to .
02
14
= function)
02
02
14
= function):
no
00
00
732783 - Rev.C
Y