Shield Installation; Installing Blade - Shindaiwa BP35 Manual Del Proprietario / Usario

8. Adjuster cover. 9. Cable adjuster.
If necessary, adjustments can be made at the carburettor by:
- Temporarily moving the adjuster cover to expose the cable adjuster.
- Loosening the cable locknut and then screwing the cable adjuster in or out until proper
free play is achieved.
- Tighten cable locknut and move adjuster cover back into place.

Shield installation

1. Bracket. 2. Shaft tube.
6. Four bolts (M5 X 45).
Insert the shield between the shaft tube and the bracket with a spacer.
Fit a spacer and the shield support on the shaft tube and tighten four bolts (M5 X 45) lightly.
Tighten the four bolts firmly.

Installing blade

If worn bolt and bolt guard for blade are used, there is a danger of blade getting loose.
Replace them with new ones.
Fasten output shaft using locking tool securely in order to avoid the possibility of
output shaft rotating when mounting cutting blade which will prevent the cutting
blade fastening bolt from being tightened sufficiently.
Wear gloves to reduce the risk of injury caused by unintentional contact with the
blade.
NOTE
Check to be sure the locking tool is fully engaged to prevent the output shaft from turning.
Inspect blades before installation.
Check for sharpness.
Dull blades increase the risk of blade kickback reactions.
Small cracks can develop into fractures resulting in a piece of blade flying off during operation.
Discard cracked blades no matter how small the crack.
1. Socket wrench. 2. Loosening direction.
5. Lower blade retainer.
8. Locking tool (4 mm hexagonal wrench).
Align locking hole in blade retainer with notch at the edge of angle transmission and insert
locking tool.
The bolt has a left hand thread and can be removed by turning clockwise.
Remove the bolt guard and lower blade retainer.
9. Safety clip off-centre.
∗ Slip the blade in place.
Slide the safety clip as shown in the illustration.
Fit the blade over the safety clip on the blade retainer and slide the safety clip back to the
original position.
Insert locking tool further into blade retainer fixing hole to fix output shaft.
11. Blade. 12. Tightening direction.
Tighten the bolt (turn anticlockwise) using a socket wrench.
Never fasten applying your too much pressure.
Otherwise the thread of bolt could be broken.
Remove locking tool.
10. Cable locknut.
3. Shield. 4. Two spacers.
DANGER
CAUTION
3. Bolt.
6. Safety clip. 7. Blade retainer.
10. Centre the safety clip.
17
5. Shield support.
4. Bolt guard.