Safety Advice Relating Specifically To This Device; Operation; Preparing The Device For Use - Parkside PHLG 2000-2 Instrucciones De Utilización Y De Seguridad

Safety advice relating
specifically to this device
½
Children or persons who lack the knowledge
or experience to use the device or whose
physical, sensory or intellectual capacities are
limited must never be allowed to use the device
without supervision or instruction by a person
responsible for their safety. Children must never
be allowed to play with the device.
ATTENTION! To avoid the danger of injury,
burning and dangers to your health:
½
If danger arises, pull the mains plug immediate-
ly out of the mains socket.
DANGER OF PERSONAL INJURY!
Never use the appliance as a hair dryer.
½
Do not direct the heat flow at persons
or animals.
½
Do not look directly into the opening of the heat
nozzle .
3
½
DANGER OF BURNS! Do not
touch the hot nozzle. Wear protec-
tive gloves.
½
Wear protective glasses.
½
DANGER OF FIRE AND EXPLO-
SION! The appliance develops
very high temperatures.
If the device is not used carefully,
it can give rise to increased risk of
fire or explosion.
½
Do not work in the vicinity of easily ignitable
gases or materials.
Heating of plastics, paints, varnishes etc. can
lead to the creation of gases that are hazard-
ous to health. Make sure you always have
adequate ventilation.
½
Let the device cool down completely before
you put it into storage. Always place your
heat gun down on its end, with the nozzle
pointing upwards.
½
In addition, you should never leave the device
working unattended.
½
When taking a break from your work, before
carrying out any tasks on the device itself (e.g.
changing the nozzle) or when you are not
General safety advice / Operation
using the device, always pull the mains plug
out of the mains socket.
½
Do not direct the device at the same spot for
too long a period.
½
Maintain a distance between the jet outlet
nozzle and the workpiece or the surface being
heated. An air blockage could lead to over-
heating of the appliance.
½
Pay heed to the direct working area and also
to its surroundings. The heat produced could
reach to inflammable articles located out of the
visible area.
½
Always keep the device clean, dry and free
of oil or grease.
½
Never use the device for a purpose for which it
was not intended.
©

Operation

©

Preparing the device for use

CAUTION! When using the device, never
allow the ventilation slots to be covered.
CAUTION! DANGER OF BURNS! Do not
touch the hot nozzle.
Switching on the device:
Press the ON / OFF switch
or "II".
Switching off the device:
Press the ON / OFF switch
Adjusting the air quantity and temperature:
You can use the temperature and air quantity control
to set two different blower levels. It is therefore
2
possible to select the appropriate quantity of air and
temperature in accordance with the intended use:
Setting I 300 l / min
Setting II 500 l / min
Use as free-standing unit / during
cooling (see Fig. D):
Always set the device down upright on
a level surface, this will allow
into setting "I"
2
into setting "0".
2
350 °C
550 °C
GB/MT 33