Monitoring - WEG SRW 01-UC Guía De Instalación, Configuración Y Operación

Table 2 (cont.): SRW 01 status via HMI
Error Type
E0075 Protection Trip or Alarm Frequency out of range
E0076 Protection Trip or Alarm Earth leakage
(***)
E0077 Protection Error or Alarm Trip inhibit (short circuit) (earth leakage)
(***)
E0078 System
E0079 System
E0080 System
E0081 System
E0082 System
E0085 System
E0086 System
E0087 Protection
E0088 Protection Trip or Alarm External Fault
E0089 Protection Trip or Alarm Underpower
E0090 Protection Trip or Alarm Overpower
E0091 Protection Trip or Alarm Power Under Factor
E0092 Protection Trip or Alarm Power Over Factor
E0150 to
System
E0199
(*) Local HMI errors are not registered in the SRW 01-UC if P229 or P232 ≠ 1.
(**) Available only in the UC version with PTC protection.
(***) Available only in the UC version with Earth Leakage protection.
Make sure that the acquired control unit model has these functionalities.

11. MONITORING

The SRW 01 monitors the following variables:
Table 3: Monitoring Parameters
Parameter
(address)
P002 %IN Current
P003 TRUE RMS Current
P004 Average Voltage TRUE RMS
P005 Line Frequency
Action
Error Check back error, start command verification
Error Check back error, stop command verification
Error Check back error, stop verification
Error Check back error, running verification
The current programmed in P401 and P402
Error
is out of the UMC/UMCT range
Error Without communication with the UMC/UMCT
Error or Fault Serial Communication Timeout (Modbus)
Trip Trip Test
Error or Fault WLP user errors
Description
Description
Range
0 - 999 %
0.0 - 9999.9 A
0 to 1000 V
0.0 - 99.9 Hz
13