Hupfer TE-2/V19-26 Manual De Instrucciones página 69

Chapter 4
Page 24
Step 1: Preparation
§
Prepare cut-outs in the worktop and the front cladding corresponding to the indicated dimensions.
The worktop cut-out dimensions are given in inch (mm) as shown in the corresponding drawing of the
built-in appliance.
The cut-out dimension for the switch is 1.2'' x 0.9'' (30x22 mm).
§
Remove the protective plastic film from the metal plates.
Step 2: Installation
NOTE
§
Insert the appliance into the worktop cut-out and fasten it.
Figure 11
Plate dispenser
TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26
Transport, Assembly, Putting into Operation and Decommissioning
Presetting the operating temperature
In contrast to the mobile appliances with the switch and controller arranged
next to each other, the switch of the built-in appliance can be placed any-
where on the front side.
Under these circumstances, the controller is no longer accessible for operat-
ing after the installation. Ensure that the desired temperature is set on the
thermostat before the installation.
Worktop cut-out EBRH/V19-26
Assembly (Built-in appliances only)
4330000_A6