Adjusting The Kick Panel - Thermador PRD305PH Manual De Instalación

Adjusting the Kick Panel

To adjust the kick panel do the following:
1. Remove the kick panel screws using a T-20 Torx
screwdriver.
2. Relocate kick panel at one of the five screw hole
positions, as noted below. Reinstall Torx screw.
3. Repeat with the remaining kick panel screws, assuring
kick panel is level.
• The range kick panel should maintain a minimum
½'' (12.7 mm) clearance above the floor.
English 21
Figure 27: Kick Panel Adjustment
Data Rating Label and Wiring Diagram
Data rating labels contain the model and serial numbers.
They can be found under the front edge of the rangetop,
with oven door open or removed.
Figure 28: Data Rating Label Location
The electric wire diagrams and schematics are attached
behind the kick panel, and should not be removed except
by a service technician, then replaced after use.