Installing Under A Continuous Worktop; Detaching The Worktop; Fitting And Mounting To Continuous Worktop - Electrolux S60170TK38 Manual De Instrucciones

12
Installation
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.

Installing under a continuous worktop

If your refrigerator is installed under a continuous
worktop, an air outlet opening of at least
2
200cm and a ventilation grille matching the
worktop design should be installed at the rear of
the worktop.
The cut surfaces of the worktop should be var-
nished to avoid swelling due to penetration of
moisture.
The appliance wall distance must be at least 30
mm and should be checked before the ventilation
grille is inserted.

Detaching the worktop

To remove the worktop, please proceed as follows:
1. Unscrew left and right screws at the front.
2. Unscrew left and right screws at the back.
3. Lift the worktop slightly at the front, push
back about 20 mm and lift off from the front.
4. Unscrew left and right screws at the back.
5. Store the screws in a safe place together with
the worktop.

Fitting and mounting to continuous worktop

Before fitting, change the door opening direction
if necessary (see: Door reversibility).
Push the appliance carefully into the niche.
Take care that the mains cable is not jammed in.
Check distance from wall (see: Installing under a
continuous worktop).
Level the appliance by screwing the two adjustable
feet at the front in or out, thus ensuring a stable
position.
With a suitable screws (depending on the design
of the worktop and the distance between the appliance and the worktop, not supplied), fix
the appliance under the worktop through the upper door hinge. If necessary, equalise the
A
3
3
4
1
5
2