Operation; Inserting Or Replacing A Tool / Collet; Switching On And Off / Setting The Speed Range - Parkside PMGS 12 B2 Instrucciones De Utilización Y De Seguridad

General safety advice for electrical power tools / operation
Avoid contact with moving sanding or
grinding tools.
DAnGEr OF FIrE FrOM FlyInG
SPArKS! Abrading metal creates
flying sparks. For this reason, always
make sure that nobody is placed in any danger
and that there are no inflammable materials
near the working area.
DUST HAzArD! Any
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
nOXIOUS FUMES!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
Avoid abrading paints containing lead
or other substances hazardous to health.
Do not machine materials containing
asbestos. Asbestos is a known carcinogen.
Do not machine moist materials or
damp surfaces.
nOTE! Do not allow the tool to come to a
standstill by overloading it!
Switch the device off
and allow it to come to a standstill be-
fore you put it down.
Always keep the device
clean, dry and free of oil or grease.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsible
for their safety. Children must never be allowed
to play with the device.

Operation

Q
never use the device for a purpose
for which it was not intended or with
non-original parts / accessories. The use
of tools or accessories other than those recom-
mended in the operating instructions could lead
to you suffering an injury.
Inserting or replacing
Q
a tool / collet
Press the spindle lock
Rotate the clamping nut
engages.
Loosen the clamping nut
tion key .
23
If a tool is already inserted, remove it.
First insert the tool you wish to use though the
clamping nut before you insert it into the
5
collet suitable for the tool shaft.
18
Press the spindle lock
Insert the collet
18
tighten the clamping nut
the combination key
Using the Insertion tool with mandrel
nOTE: Use the screwdriver end of the combi-
nation key to release or tighten the screw of
23
the mandrels .
13
Insert the mandrel
13
described.
With the aid of the combination wrench
unscrew the screw from the mandrel
Place the insertion tool you wish to have onto
the screw between the two washers.
With the aid of the combination wrench
tighten the screw on the mandrel
Switching on and off /
Q
Setting the speed range
Switching on / Setting the speed range:
Connect the plug
4
by inserting it into the plug-in device
for such purposes (see Fig. C).
and keep it pressed.
7
until the lock
5
with the combina-
5
and keep it pressed.
7
into the threaded insert and
on the thread using
5
.
23
into the electrical tool as
23
.
13
23
.
13
to the power supply unit
provided
8
GB/MT
:
13
,
,
10
53