Taski swingo 4000 Manual De Instrucciones página 94

• Select the desired dosing by press-
ing the +/- buttons from level 1-6.
Notice:
Diversey recommends a sustainable work-
ing by determination of the correct product
dosing quantity. Overdosing or underdos-
ing will lead to unsatisfactory cleaning re-
sults.
Notice:
TASKI offers an automatic dosage feature
as an option. It is possible to mount it addi-
tionally. Please contact your customer ser-
vice.
• Press the Brush drive ON/OFF but-
ton.
The display lights up, the brush unit
is lowered and the engaging process
starts automatically.
• Select the desired brush pressure
rating by pressing the +/- buttons
from level 1-3.
Notice:
Always calculate and select the lowest lev-
el that is sufficient for good cleaning re-
sults. Thus you will optimize power
consumption and increase the service life
of the machine.
ECO mode
• The ECO mode is activated by press-
ing the ECO mode ON/OFF button.
By doing so, the speed of the suction
motor is reduced and the dosage of
the cleaning solution is set to level 2
and the brush pressure is set to level
1.
Notice:
If required, the level of the cleaning solu-
tion can be adjusted manually in ECO
mode. The ECO mode is suitable for
smoother floors without joints.
Starting the machine using the program button
• By pressing the program button for
the next operation start or work step,
all machine functions are started on
the basis of the functional values last
used.
Notice:
By pressing a button again, the function
will be reprogrammed.
92
Notice:
The preset values can be adjusted at any
time during operation. The values preset
when switching off the machine are stored
and will be automatically activated when
restarting the machine.
Notice:
Pressing the program button when the
cleaning process is finished will start an
optimized program for the end of opera-
tion. See instructions on page 93 in the
"Automatic process" chapter.
Settings and activated functions are
saved.
Cleaning start
• If the machine is switched on and the
operator is sitting on the driver seat,
the machine starts moving as soon
as the gas pedal is depressed. If se-
lected, the brush unit is started and
the cleaning solvent supply is open.
The speed is controlled by the posi
tion of the gas pedal. When releasing
the gas pedal, the machine is decel
erated until it stops and the parking
brake is activated. The supply of the
cleaning solution will be interrupted,
then the brush unit will be stopped
with a delay.
Notice:
The supply volume of the cleaning solution
is adjusted to the corresponding working
speed. (IntelliFlow)
Attention:
When working in restricted or narrow ar-
eas, it is recommended to press the slow
approach ON/OFF button. (Display lights
up) The maximum working speed is re-
duced, and thus so is the risk of accidents.
• Pressing this button once more will
override this restriction, and the dis-
play disappears.
Battery capacity - end of operational readiness
The battery level indicator provides information on the avail-
able operating time.
• If the red indicator begins to flash, approx. 5 minutes of
residual working time are left.
• After this period, the brush unit and – 30 seconds later –
the squeegee is lifted. The red display switches to continu-
ous light.
• Now 10 more minutes remain for driving the machine to the
charging station. Then the machine is automatically
switched off.
• In order to restart, the batteries must be fully charged.
-
-