Installation - VDS AG FUTURE Manual De Instrucciones

Position the plate provided
(Fig. 1) 50 mm from the edge
of the gate and perfectly square
at an angle of 90°.
Before fastening the plate with
cement, dowels or other means,
thread the cable sheath(s)
through the prepared holes.
Remove the cop cover, unscrew the screws A and
remove the cover B and route the cables into the slot
of the motor. (Fig.2).
Fasten the rack to the gate firmly,
leaving a distance of between
2 and 3 mm from the motor pinion
(Fig.3).
2-3mm
Fasten the limit stop plates (Cams G)
of the motor on the rack. (Fig. 4)
Fig. 4

INSTALLATION

Fig. 3
G
holes cable
passage
Fig. 1
A
Fig. 2
Emergency release
1. Insert the key provided into the
appropriate cylinder and turn the
key.
Pull the lever until it stops
2.
Fig. 5
50 mm
Rack
Plate
B
Wheel