Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 7 CP27xx interfaces
1 DVI-I interface
2 USB 2.0 interfaces (4x)
3 LAN1 Ethernet adapter 10/100/1000 BASE-T with
RJ-45
4 LAN2 Ethernet adapter 10/100/1000 BASE-T with
RJ-45
Connect to external devices (optional)
Network and access point security is the responsibility of the customer that uses the wireless instrument. The
manufacturer will not be liable for any damages, inclusive however not limited to indirect, special, consequential
or incidental damages, that have been caused by a gap in, or breach of network security.
Maintenance
Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
Do not disassemble the instrument for maintenance. If the internal components must be cleaned or repaired,
contact the manufacturer.
CX5130—Replace the battery or CFast card
Electrocution hazard. Remove power from the instrument before doing maintenance or service
activities.
Note: Make sure that the battery is installed in the correct polarity and it is the correct type. Refer to
specifications
on page 14.
To replace the battery, refer to the illustrated steps that follow.
12 English
5 Power supply, refer to
6 Ground
7 D-Sub9 to connect the RTC through LZH169
N O T I C E
C A U T I O N
N O T I C E
D A N G E R
Figure 5
on page 10
Battery
Publicidad
