Chicco HUMI AMBIENT Manual Del Usuario página 32

the switch (10) counter-clockwise.
standby function by pressing down on the
switch (10) for at least 2 seconds.
ble plug from the mains.
FUNCTION FOR PROTECTING THE DE-
VICE FROM LACK OF WATER
(2) and heating tank (13), when the device is
turned on, the humidifier will return to stand-
by mode and the buzzer will issue a "beep". To
turn the device on again, unplug the power
cable from the mains socket and fill up the
water tank again as indicated in the "PRE-
LIMINARY OPERATIONS" paragraph.
no water in the water tank (2) and heating
tank (13) the humidifier will stop heating
and return to standby mode, the buzzer will
issue a "beep" and the fan will stay on for ap-
proximately 30 seconds.
power cable from the mains socket, wait for
the humidifier to cool down completely and
again fill up the water tank as indicated in the
"PRELIMINARY OPERATIONS" paragraph.
EMERGENCY THERMOSTAT
should the emergency thermostat be ac-
tivated the humidifier will return to run in
standby mode, the buzzer will issue a "beep",
the LED (11) will remain on issuing an inter-
mittent red light and the functions of the
button (10) will remain deactivated.
activated, unplug the power cable (5)
from the mains, allow the device to cool
completely, avoid trying to turn it on
again and refer to the section "PROB-
LEMS AND SOLUTIONS".
FAN INTERRUPTION
MODE
returns to run in standby mode, the buzzer
-
CLEANING & MAINTENANCE
WARNING!
CLEANING THE TANK (2), STEAM DUCT
(4), HEATING TANK (13) AND HEATING
PLATE (12)
PROTECTION
32
issues a warning "beep" at regular 1-second
intervals, the LED (11) flashes red continu-
ously and the functions of the power on and
regulation button (10) are deactivated. The
warning will remain active until the plug
of the power cable (5) is removed from the
mains socket. The humidifier must not be
used again. To repair the device, contact
technical service centre.
Before performing the clean-
ing/maintenance operations indicated in
this paragraph, turn off the humidifier, un-
plug the power cable (5) from the mains
socket and allow the device to cool down
completely.
soft cloth. Avoid using abrasive detergents,
alcohol, solvents or similar products that can
cause irreparable damage to the surfaces of
the device.
use chemical or abrasive products to clean it.
ing filter (7), remove it from its position by
sliding it out, then remove the dust present
in the surface with the aid of a small soft
brush, rinse gently under cold running wa-
ter, leave to dry in the air without exposing it
to direct sunlight, then put it back on to the
device in its original position
ponents in dishwashers.
mineral salts dissolved in the water can cause
encrustation to form due to limescale in the
steam duct(4), heating tank (13) and heating
plate (12).
-
-
-