Kohler K-6880 Guía De Instalación Y Cuidado página 7

2.
Install the Lavatory
1-3/8"
(3.5 cm)
Bolt
Boulon
Perno
Temporarily thread a cap nut (provided) onto each bolt (provided).
Using a 9/16" open-end wrench, thread the bolts into the mounting holes.
Approximately 1-3/8" (3.5 cm) of the bolt must protrude out from the finished
wall.
Remove and retain the cap nuts.
Install the faucet and drain to the lavatory according to the manufacturer's
instructions. Do not fully tighten the drain slip-joint connections at this time.
With assistance, lift and position the lavatory. The lavatory must be onto the lip of
the installed hanger and the bolts in the wall must be protruding through the
mounting holes on the underside of the lavatory.
Slide a washer over each bolt. Thread a cap nut onto each bolt. Do not overtighten
the cap nuts.
Fully tighten the drain slip-joint connections and connect and tighten the trap to
the drain. Complete the water supply connections to the faucet according to the
instructions packed with the faucet.
Run water into the lavatory and check all connections for leaks.
Installer le lavabo
Enfiler temporairement un écrou borgne (fourni) sur chaque boulon (fourni).
Utiliser une clé à fourche de 9/16" pour enfiler les boulons dans les orifices de
fixation. Approximativement 1-3/8" (3,5 cm) du boulon doit dépasser du mur fini.
Retirer et conserver les écrous borgnes.
Kohler Co.
Washer
Rondelle
Arandela
Cap Nut
Écrou borgne
Tapón roscado
7 1007272-2-C