Publicidad
Idiomas disponibles
Idiomas disponibles
Chapter 1
Bottom Panel
Reset
The Reset button is located on the
right side of the product label. There are two
ways to reset the Router to its factory defaults.
Either press and hold the Reset button for
approximately five seconds, or restore the
defaults from the Administration > Factory
Defaults screen of the Router's web-based
utility.
Horizontal Placement
The Router has four rubber feet on its bottom panel. Place
the Router on a level surface near an electrical socket.
Wireless-N Broadband Router with Storage Link
152 mm
Print this page at 100% size.
Cut along the dotted line, and place on the wall to drill precise spacing.
Wall-Mounting Template
Wall-Mounting Placement
The Router has two wall-mount slots on its bottom panel.
The distance between the slots is 152 mm (6 inches).
Two screws are needed to mount the Router.
Suggested Mounting Hardware
4–5 mm
1–1.5 mm
Note: Mounting hardware illustrations are not
†
true to scale.
NOTE:
Linksys is not responsible for damages
incurred by insecure wall-mounting hardware.
Follow these instructions:
1.
Determine where you want to mount the Router.
Make sure that the wall you use is smooth, flat, dry and
sturdy. Also make sure the location is within reach of
an electrical socket.
2.
Drill two holes into the wall. Make sure the holes are
152 mm (6 inches) apart.
3.
Insert a screw into each hole and leave 3 mm
(0.12 inches) of its head exposed.
4.
Manoeuvre the Router so the wall-mount slots line up
with the two screws.
5.
Place the wall-mount slots over the screws and slide
the Router down until the screws fit snugly into the
wall-mount slots.
Product Overview
2
Publicidad
Capítulos
