Publicidad
d. REASSEMBLY
1) Apply gear oil to the circumference of a new needle
bearing.
1
2) Drive the 22 x 28 x 20 mm needle bearing into the propeller
2
shaft holder using the special tools and hydraulic press as
shown.
3
• Install the needle bearing with the stamped side toward
the special tools.
4
TOOLS:
5
Drover
Attachment, 28 x 30 mm
Pilot, 22 mm
6
7
8
9
10
11
12
3) Apply gear oil to the circumference of a new bearing.
13
4) Set a wood block under the reverse bevel gear.
14
5) Drive the 6007 radial ball bearing into the reverse bevel
15
gear using the special tools and hydraulic press as shown.
16
TOOLS:
Driver, 40 mm I.D.
Inner driver, 35 mm
17
18
19
20
11-14
[1]
DRIVER
07749-0010000
07749-0010000
07946-1870100
07746-0041000
[4]
22 x 28 x 20 mm
NEEDLE BEARING
[1]
6007 RADIAL BALL
BEARING
07746-0030100
07746-0030400
[5]
INNER DRIVER, 35 mm
07746-0030400
248
[2]
ATTACHMENT,
28 x 30 mm
07946-1870100
[3]
PILOT, 22 mm
07746-0041000
[2]
DRIVER, 40 mm I.D.
07746-0030100
[3]
WOOD BLOCK
[4]
REVERSE BEVEL
GEAR
Publicidad
Capítulos
