Tools And Materials; Before You Begin - Kohler K-9530 Guía De Instalación Y Cuidado

Tools and Materials

Adjustable
Drill and
Wrench
Hole Bit
Tape
Propane
Measure
Torch

Before You Begin

WARNING: Risk of personal injury. This product is a
diverter valve only and should never be used as a shut-off
valve. Doing so would allow cross flow between the hot and
cold water supplies and create a serious scalding hazard.
Observe all local plumbing and building codes.
Shut off the main water supply.
Provide an access panel for all installations.
Carefully read this entire instruction manual before beginning the
installation; the illustrations do not show all possible
configurations.
This diverter can be installed to decks with a maximum thickness
of 1-1/4" (32 mm).
Carefully inspect waste and supply tubing for any sign of
damage. Replace if needed.
You can extend the distance between the water source and the
braided hose connection with 1/2" copper piping below the rim
of the bath/whirlpool, but it may not be safe or practical. A long
run of piping will mean a long run of room-temperature standing
water when the handshower is first activated for use.
This diverter can be used in either a deck-mount or wall-mount
installation. Refer to the "Diverter Configurations" section for any
special considerations.
Do not install spouts with flow restrictors or handheld shower
units on the large (5/8" OD) bath outlet.
1229813-2-A
Plus:
• Supply piping,
connectors, and caps
3/32" Hex
Wrench
Solder
2 Kohler Co.