Power Supply; Control Buttons; Operating Instructions - Weston PRO Serie Manual De Instrucciones

CONTROL BUTTONS

STOP BUTTON
Pressing the Stop Button stops to halt the vacuuming process Figure 3.
MANUAL SEAL BUTTON
Press the Manual Seal Button during the vacuuming process to initiate the seal
(before the preset vacuum pressure is reached) Figure 3.
START BUTTON
Press the Start Button to initiate the vacuuming process (the Vacuum Sealer
will automatically seal the bag when a preset vacuum pressure is reached)
Figure 3.
R e c on n e c t with Re a l F ood
VACUUM
PRO-2100
SEALER
U.S. P atented

OPERATING INSTRUCTIONS

WARNING!
Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS
REMOVED FROM THE OUTLET/POWER SOURCE!
· CAUTION: The Seal Bar Heating Element and Vacuum Lid Seal get HOT! Avoid
touching them. Be careful while loading bags into the Vacuum Chamber.
· DO NOT try to open the Vacuum Lid before the vacuum has released or unit
damage may occur.
· Wait at least 20 seconds between cycles to avoid overheating the unit.
· DO NOT allow liquids, powder or other small substances to be sucked into the
Vacuum Port or unit damage may occur. Press the "Stop" Button to hault the
vacuum process. Use the "Manual Seal" Button when vacuum sealing liquids.
· The Vacuum Sealer is ONLY intended to be used with VACUUM BAGS.
For best results, only use the recommended vacuum bags. DO NOT USE
HOUSEHOLD BAGS! Any other uses of the Vacuum Sealer, other than the
uses described in this booklet, could potentially damage the appliance and void
the warranty.
1. Make sure the Vacuum Sealer is in the "OFF" position. Attach the Vacuum
Sealer to the power supply.
2. Turn the Vacuum Sealer "ON".
3. The "POWER" Light on the display, "POWER INDICATOR" Switch both will
illuminate and the Internal Cooling Fan will run.
4. Open the Vacuum Lid.
QUICK REFERENCE GUIDE
AUTOMATIC VACUUM SEAL
1. PLUG power cord into 120-Volt outlet
2. Turn the POWER SWITCH to the "ON" position
3. Place VACUUM BAG OPEN END into VACUUM CHAMBER (See Instruction Book for Details)
4. CLOSE LID – APPLY PRESSURE to HANDLE – push START button
5. The machine will VACUUM and SEAL automatically*
MANUAL SEAL MODE
MANUAL SEAL MODE is used to disengage the vacuum pump and engage the sealing function manually
1. Follow steps 1-4 of the Automatic Vacuum Seal Instructions
2. When the desired vaccum is reached, press the MANUAL SEAL BUTTON
3. The machine will begin sealing the bag*
* The Sealing Time is pre-set to 3 seconds. The Cooling Time is pre-set to 3 seconds.
THIS IS ONLY A QUICK REFERENCE GUIDE. THOROUGHLY READ AND UNDERSTAND
THE SUPPLIED INSTRUCTION MANUAL BEFORE USING THIS APPLIANCE.
Before cleaning, assembling or disassembling the
FIGURE 3
STOP
POWER
VACUUM
MANUAL SEAL
SEAL
START
COOL
9