ARIETE Cafe Chic 1377 Manual De Instrucciones página 17

proBLem Cause
the coffee is not The holes of the filter holder
supplied or flows
coupling seat are clogged.
too slowly.
The exit holes of the filter
containing coffee grounds are
clogged.
The coffee blend is ground
too fine.
The coffee blend is pressed
down too much.
The tanks is not inserted well.
The hole of the silicone disc is
clogged.
There is little water and the
pump does not suck it up.
Faulty pod
Broken pod
the coffee is too
The blend has been ground too
watery and cold. coarsely.
soLutions
Turn on the machine without the filter holder, making the
water run. If the water still does not come out from all the
holes evenly, carry out the descaling cleaning operation using
the Ariete NOCAL product found at Ariete service centres,
following the instructions provided in the package.
Slowly remove and disconnect the filter holder because any
remaining pressure could cause splashes or squirts. Clean the
clogged filter holes with a small brush or a pin. Clean the filter
using Ariete COFFEE CLEAN tabs, following the instructions
provided in the package.
Try using coarser coffee blends.
Tamper coffee inside the filter using less pressure.
Fit the tank securely by pushing it as far as it will go.
Wash the silicone disc (O) under running water, bending it
slightly on the sides in order to free the centre hole of any
residue of coffee grounds that could clog it (Fig. 10).
Check that the water level in the tank is correct. If necessary,
fill it with cool tap water.
Replace the pod in the filter holder (T)
Remove the pod filter holder (T), clean the seat with a sponge,
and put a new pod inside.
A more finely ground blend must be used to obtain a more
concentrated and hotter coffee. Anyhow, this problem is easily
solved thanks to the Thermocream® System, which always
guarantees hot coffee accompanied by a reach cream, even
with coarsely ground beans.
17