Air Supply - Bostitch BT125 Manual De Operación Y De Mantenimiento
Engrapadoras neumaticas
Ocultar thumbs
Ver también para BT125:
- Manual de operación y de mantenimiento (32 páginas) ,
- Manual de operación y de mantenimiento (32 páginas)
Publicidad
Idiomas disponibles
Idiomas disponibles
AIR
SUPPLY
AND
CONNECTIONS
[_WARNING:]
Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as
tool may explode, possibly causing injury.
FITTINGS:
Install a male plug on the tool which is free flowing
and which will release
air pressure
from the tool when
disconnected
from the supply source.
HOSES:
Air hoses should
have a minimum
of 150 p.s.i. (10.6 KG/CM 2) working
pressure
rating or 150 percent of the
maximum pressure
that could be produced in the air system.
The supply hose should contain a fitting that will
provide "quick disconnecting"
from the male plug on the tool.
SUPPLY SOURCE:
Use only clean regulated compressed
air as a power source for this tool. NEVER USE OXYGEN, COMBUSTIBLE
GASES, OR BOTTLED GASES, AS A POWER SOURCE FOR THIS TOOLAS TOOL MAY EXPLODE.
REGULATOR:
A pressure
regulator
with an operating pressure
of 0 - 125 p.s.i. (0 - 8.79 KG/CM _) is required to control the
operating pressure
for safe operation of this tool. Do not connect this tool to air pressure which can potentially
exceed 200 p.s.i. (14 KG/CM 2) as tool may fracture or burst, possibly
causing injury.
OPERATING
PRESSURE:
Do not exceed recommended
maximum
operating
pressure
as tool wear will be greatly increased.
The air
supply must be capable of maintaining
the operating pressure
at the tool. Pressure drops in the air supply can
reduce the tool's driving power. Refer to "TOOL SPECIFICATIONS"
for setting the correct operating pressure
for the tool.
FILTER:
Dirt and water in the air supply are major causes of wear in pneumatic
tools. A filter will help to get the best
performance
and minimum
wear from the tool. The filter must have adequate
flow capacity for the specific
installation.
The filter has to be kept clean to be effective in providing clean compressed
air to the tool. Consult
the manufacturer's
instructions
on proper
maintenance
of your filter. A dirty and clogged
filter will cause a
pressure
drop which will reduce the tool's performance.
-6-
Publicidad
