Publicidad
Idiomas disponibles
Idiomas disponibles
● Slave Mode : Auto
● Sound State : off
● Pan inverse : No
● Tilt inverse : No
(Notice:other settings are NOT changed while choosing Defaults Setting!)
Press the ENTER and the corresponding functions will set to defaullts setting,to go back to the
functions without any change press MENU button again.Hold and press the MENU button about
one secon or wait for one minute to exit the menu mode.
Reset
Press the MENU button up to when the Reset is blinking on the display Pressing ENTER button
and all channels of the unit will return to their standard position.
3. How To Control The Unit
4. You can operate the unit in three ways:
● Master/slave built - in preprogram function
● Universal dmx controller
No need to turn the unit off when you change the DMX address
Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection,the first unit will control the
other units to give an automatic,sound activated,synchronized light show.This
function is good when you want an instant show.You have to set the first unit in
master mode show mode and select AUTO or sound mode.its DMX input jack will have
nothing plugged into it,and its master led will be constantly on and sound led will
flash to the musi c.The other units will have to set in slave mode and select Slave
mode,Their DMX cables plugged into the dmx input jacks(daisy chain)and the slave
led lights will constantly on.
4.2 DMX Controller
Select DMX Address ,press the enter button to confirm,the present address will blink on the
display. Use the UP and DOWN button to adjust the address from 1 to 512.Once the address has
been selected,press the ENTER button TO setup ,to go back to the functions without any change
press the MENU button again. Button again. Hold and press the MENU but ton about one second
or wait for one minute to exit the menu mode.
MINI BEAM 101
User Manual/Manual de uso
Pag 6
EN
Publicidad
