Klarstein 10031386 Manual De Instrucciones página 25

6
TIMER
HEALTH
7
iCLEAN
8
9 TURBO
25
• With the unit ON, press this button
to set OFF timer or with it OFF to set
ON timer.
• Press this button once, a "ON(OFF)"
will flash.
• Press the ARROWS (up/down) to set
the number of hours in which the unit
will be turned ON/OFF, with an inter-
val of 0.5 hour if less than 10 hours, or
• 1 hour if longer than 10 hours , and a
range of 0.5-24 hours.
• Press it again to confirm the setting,
the "ON (OFF)" will stop flashing.
• If the timer button is not pressed lon-
ger than 10 seconds after the "ON
(OFF)" start flashing, the timer setting
will be exited.
• If a timer setting is confirmed, pres-
sing this button again will cancel it.
• Note: When a ON timer is set, all
function buttons (except SLEEP, DIS-
PLAY and iFEEL can't be set ) are valid
and when the ON time set is up, the
unit will operate as preset.
Press this button with the unit ON to activate health related functions, such as negative
ion, electrostatic precipitation, PM2.5 removal, etc, depending on the actual configurati-
on of each model. Press this button again to deactivate the HEALTH function.
Press this button with the unit OFF, the remote controller will display "CL" and the unit
will automatically clean dust off the evaporator and dry it, to increase the cooling and
heating efficiency. The iCLEAN function runs for approximately 30 minutes, during
which if the unit is turned on with the remote controller or this button is pressed again,
the iCLEAN will be deactivated.
Each time the ARROW UP is pressed, the temperature setting will increase by 1°C and
each time the ARROW DOWN is pressed, it will decrease by 1°C. The temperature set-
ting ranges from 16°C (60°F) to 32°C (90°F). Note: The temperature cannot be set in
AUTO or FAN mode, thus these two buttons are not functional.
Press this button only in COOL or HEAT mode to set TURBO on or off to speedy the
cooling or heating. When TURBO is on, the air speed is HIGH. When TURBO is off, the
air speed will restore to previous status.