Tabla de contenido
Publicidad
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY
RULES BEFORE OPERATING YOUR UNIT.
1
A
2
2
A. Curved shaft models
B. Straight shaft models
1. Shaft
2. Trimmer Head
3. Shield
4. Locking Sleeve Assembly (Knockdown shaft models)
5. Assist Handle
6. Throttle Trigger
7.
8. Primer Bulb
9. Spark Plug
10. STOP Switch
11. Starter Handle
12. Choke Lever
13. Fuel Mix Fill Cap
BEFORE STARTING ENGINE
a WARNING: Be sure to read the fuel information in the
safety rules before you begin. If you do not understand
the safety rules, do not attempt to fuel your unit. Call
customer support.
FUELING ENGINE
a WARNING: Remove fuel cap slowly when refueling.
HELPFUL TIP: To obtain the correct oil mix ratio, pour 2.6
ounces of 2-cycle synthetic oil into one gallon of fresh gas.
IMPORTANT: This equipment is designed to operate on
unleaded gasoline with a minimum 87 octane (R+M/2
method), with ethanol blended up to 10% maximum by
volume (E-10). Before operation, gasoline must be mixed
with a good quality synthetic 2-cycle air-cooled engine oil
designed to be mixed at a ratio of 50:1. Poulan/WEED
EATER brand synthetic oil is recommended. Mix gasoline
and oil at a ratio of 50:1. A 50:1 ratio is obtained by mixing
DO NOT USE automotive oil or marine oil.
These oils will cause engine damage. When mixing fuel,
follow instructions printed on container. Once oil is added
to gasoline, shake container momentarily to assure that
OPERATION
3
B
3
Compare the illustrations with your unit to familiarize
yourself with the location of the various controls and
adjustments. Save this manual for future reference.
5
4
6
1
the fuel is thoroughly mixed.
Always read and follow the safety rules relating to fuel
before fueling your unit. Purchase fuel in quantities that
can be used within 30 days to assure fuel freshness.
CAUTION: Never use straight gasoline in your unit.
This will cause permanent engine damage and void
the limited warranty. Do not use alternate fuels such as
ethanol blends above 10% by volume (E-15, E-85) or any
methanol blended fuel. Use of these fuels can cause major
engine performance and durability problems.
STOPPING
HOW TO START YOUR UNIT
a WARNING: The trimmer head will turn while starting
HELPFUL TIP: If your engine still does not start after
following these instructions, please call customer support.
STARTING POSITION
4
10
8
11
13
The STOP switch is used to stop the
engine. Push the switch in the STOP
position until the engine stops.
12
9
7
Publicidad
Tabla de contenido
