HoMedics TONY LITTLE DESIGNS AG-3501TL Manual De Uso página 3

Assembly Instructions
Important Notice:
If you experience any
1. Carefully remove all contents from the packaging and inspect the
type of distortion or
product to make sure all components of the recliner are present.
interference to radio These should include (figure 1):
or television reception • Right side armrest with hand control pocket (A)
• Left side armrest (B)
when turning the unit
• Crossbars (C) & (D)
to the ON position,
• Cup holder (E)
immediately turn
• Back and leg frames with attached slip covers (F) (G)
the unit off. Wait a
• Small nuts and washers (8) (H)
few seconds before
• Large bolts (8) (I)
turning the unit on and
• Allen wrench (J1)
distortion/interference
• Open end wrench (J2)
should be eliminated.
• Massage mat with attached hand control (K)
• Detachable headrest (L)
• AC adaptor (M)
G
D
A
C
E
H
I
L
B
H
K
M
F
J1
J2
4
2. Assemble Chair Base:
• Attach both crossbars (figure 2) to the right hand armrest, matching
corresponding numbers, and insert large bolts. Tighten partially with
Allen wrench.
• Attach both crossbars to left side armrest, matching the corresponding
letters, and insert large bolts (figure 3). Tighten partially
with the Allen wrench. Stand base upright.
3. Attach Back Frame to Base:
• Slide the back of the chair into the frame with the straps facing the
chair (figure 4).
• Align the back by inserting the large bolts into the frame.
• Place a washer and nut over each bolt to secure the Back
Frame to the Chair Base. Use open end wrench to tighten partially
(figures 5A and 5B).
Figure 1
Figure 2
Figure 4 Figure 5A
5
Figure 3
Figure 5B