Publicidad
Idiomas disponibles
Idiomas disponibles
Parts supplied
for installation:
l
base grille
l
miscellaneous
parts bag
Check that all parts were included.
To prevent
damage to product
or
floor covering:
l
Do Not lower the refrigerator
against the shipping
base when
removing
the shipping
base.
l
Do Not remove protective
film
until refrigerator
is in operating
position.
l
All four leveling
legs must
contact the floor to support
and
stabilize
the full weight
of the
refrigerator.
l
Keep cardboard
shipping
piece
or plywood
under refrigerator
until it is installed
in operating
position.
1
Remove
and save literature
. package
and parts bag taped
to
5
Place top of cardboard
ld
. carton
or plywood
under
refrigerator
door. Remove four
refrigerator.
Remove
dolly. Open
brackets
(two on each side) attaching
appliance
doors and remove
all boxes,
shipping
base to refrigerator
bottom.
parts packages
and packing
materials
Do Not remove tape and door
from refrigerator
and freezer
bracing
until product
is secured in
compartments.
Do Not remove
final location.
See Page 3.
protective
film.
Move the refrigerator
straight
back and
evenly
into the opening.
Check that:
l
copper
tubing
is not kinked.
l
power
supply
cord is on top of
L.
Place
appliance
dolly
under
refrigerator
side and
loosely
wrap dolly
-C--.-
refrigerator.
3
Place sections of shipping
carton
. on the floor when
rolling
dolly
and refrigerator
into the house. Move
refrigerator
close to built-in
opening.
Injury Hazard
Because of the weight
and size of
the refrigerator,
two or more
people are required
to install it.
Most of the refrigerator's
weight
is
at the top. Extra care is needed
when moving
the refrigerator
to
prevent
tipping.
Failure to follow
these instructions
could result in injury.
4
Set'power
at top of cabinet
to "OFF" position.
Plug power
supply
cord into
grounded
outlet.
Install retainer
on
grounded
outlet
using
screw from parts bag.
refrigerator
next to cover.
compression
union
L
1
compression
nut
nut
l/4"
(6
mm)
sleeve
Slide a compression
nut and sleeve on
open end of each copper
line. Use a
copper
tubing
union to connect
both
copper
lines.
Do Not over-tighten.
Turn water
supply
valve to "OPEN"
position.
Turn refrigerator
switch
"ON."
Wait a few minutes.
Check
water
line connection
and water valve
on top of cabinet
for leaks. Without
kinking
the tubing,
carefully
place it
back underneath
cabinet.
Insert carton
corner
posts between
strap and refrigerator
at side trim
Check that water supply line has
pieces and handles.
Carefully
tighten
been flushed.
See Page 7.
strap making
sure side trim and
6
Pull copper
line from refrigerator
handles
are protected.
. water valve and copper
line from
plumbing
forward
from underneath
Page 8
refrigerator.
Remove cap from water line.
Publicidad
