Descargar Imprimir esta página

Servicing Air Cleaner - Briggs & Stratton 030319 Manual Del Operario

Ocultar thumbs Ver también para 030319:

Publicidad

Idiomas disponibles

Idiomas disponibles

J
Use low pressure
air (not to exceed
25 psi) to blow
away dirt. Inspect
cooling air slots and openings
on the
generator.These
openings
must be kept clean and
unobstructed.
DO NOT
expose
generator
to excessive
moisture,
dust, dirt,
or corrosivevapors.
DO NOT
insert
any objects
through
cooling
slots.
ENGINE
MAINTENANCE
WARN(NG
WNEN
ADJUSTING
OR MAKING
REPAJRSTOYOUR
GENERATOR
Disconnect
the spar[< plug wire from
the spar[< plug and place
the wire where
it cannot
contact
spar[< plug.
WNENTESTJNG
FOR ENGINE
SPARK
Use approved spar[< plug testen
DO NOT check for spark with spark plug removed,
Oil
Oil Recommendations
NOTE:
When
adding oil to the engine crankcase,
use only
high quality detergent
oil classified "For Service SF, SG, SH,
SJ" or higher. DO NOT use special additives.
I.
Choose
a viscosity
according
to the following table:
104 F
86
68
50
32
14
4
-22
40 C
)
30
i
10
)
0
-10
-20
-30
J
NOTE:
Synthetic
oil meeting
ILSAC GF-2,API
certification
mark and API service
symbol with "SJiCF ENERGY
CONSERVING"
or higher, is an acceptable
oil at all
temperatures.
Use of synthetic
oil does not alter
required
oil change
intervals.
SAE 30:40
°F and higher G °C and higher) is good for all
purpose
use above 40°F, use below
40°F will cause hard
starting.
J0Wo30:0
to 100 °F (-18 to 38 °C) is better
for varying
temperature
conditions.This
grade of oil improves
cold
weather
starting, but may increase
oil consumption
at
80°F(27°C)
or higher.
*Check
oil level frequently
at higher temperatures.
Synthetic
BW-30:-20
to I20 °F (-30 to 40 o© provides
the best protection
at all temperatures
as well as improved
starting
with less oil consumption.
SWo30:40
°F and below (5 °C and below,) is recommended
for winter
use, and works
best in cold conditions.
Checking
Oil Level
Oil level should
be checked
prior to each use or at least
every 5 hours of operation.
Keep oil level maintained.
I.
Make sure generator
is on a level surface.
2.
Remove oil dipstick
and wipe dipstick
with clean cloth.
Replace and tighten
dipstick.
Remove and and check oil
level.
3.
Verify oil is at"Full"
marl< on dipstick. Replace and
tighten
dipstick.
Adding
Engine
Oil
I.
Make sure generator
is on a level surface.
2.
Check
oil level as described
in "Checking
Oil Level".
3.
If needed, slowly pour oil into oil fill opening
to the
°°Full" marl< on dipstid<. DO NOT overfill.
4.
Replace and tighten
dipstick.
Servicing
Air Cleaner
Your engine will not run properly
and may be damaged if
you run it with a dirty air cleaner.
Replace the air cleaner
every 25 hours of operation
or
once each year, whichever
comes
first. Replace more
often
if operating
under
dirty or dusty conditions.

Publicidad

loading

Este manual también es adecuado para:

030320