Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
WHEN
ADJUSTING
OR MAKING
REPAIRSTO¥OUR
GENERATOR
Disconnect
the spar[< plug wire from the spar[< plug and place
the wire where it cannot contact
spark plug.
WNENTESTING
FOR ENGINE
SPARK
* Use approved spar[< plug testen
DO NOT check for spark with spark plug removed.
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment
to cool before touching.
Keep at [east 5 ft. ([ 52 cm) clearance on at[ sides of generator
including
overhea&
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property
require equipment
powered
by an internal
combustion
engine to have a spar[< arrester, maintained
in
effective working
ordemqcomplying
to USDA Forest service
standard 5100-1C or later revision. In the State of California
a
spar[< arrester
is required under section 4442 of the California
Public resources
code. Other
states may have similar laws.
CAUTION
DO NOT tamper with governed
speed. Generator
supplies
correct
rated frequency
and voltage when running at governed
spee&
DO NOT modify generator
in am/way.
See "Don't
Overload
Generator".
Start generator
and let engine stabilize before connecting
electrical
loads.
Connect
electrical
loads in OFF position, then turn ON for
operation.
Turn electrical
loads OFF and disconnect
from generator
before stopping generaton
Use generator
only for intended uses.
[f you have questions about intended use, as[< dealer or ca[[
[ -800-743-4115.
Operate
generator
only on [eve[ surfaces.
DO NOT expose generator
to excessive moisture, dust, dirt,
or corrosive
vapors.
DO NOT
insert
any objects
through
cooling
slots.
If connected
devices
overheat,
turn them
off and disconnect
them
from generatom:
Shut off generator
if:
-e[ectrica[
output
is lost;
-equipment
sparks,
smokes,
or emits flames;
-unit vibrates
excessive[y_
1
Publicidad
