Installation; Siting; Cleaning; General - eunasa 3GN 1/1 Manual De Instalación, Uso Y Mantenimiento

INSTALLATION, USAGE AND MAINTENANCE MANUAL
Before starting the cooler up, we would like to thank you for the confidence you have placed in us on
purchasing this machine, and recommend you read and follow the steps detailed in the instructions.
This manual is designed to offer the information necessary for the installation, start-up, and maintenance of
the Temperature Coolers.
The special installation and maintenance must be carried out by qualified technicians.
OPERATING TESTS
The Cooler you have purchased is prepared for its correct operation, the result of which is certified by a
rigorous quality control test.

INSTALLATION

1

1.0 SITING

Remove the packaging except the support pallet. It should not be dragged over the floor.
The instructions to ensure that it is not damaged during transport/storage and loading/unloading are marked
on the packaging. You should comply with the regulations in your country for disposing of the packaging.
The area where it is positioned must be clear and clean, preventing the refrigerator equipment's fan from
absorbing materials, which are then deposited on the condenser's ribbing, reducing the efficiency of the
system.
Remove the pallet, taking care not to knock it. It can now be levelled, screwing in or unscrewing the legs.
When it is levelled, the protective film can be removed from the stainless steel using a blunt object, avoiding
scratching the steel (aluminium is recommended)

1.1 CLEANING

Before start-up:
Clean the inside of the chamber and accessories with some water and neutral soap to remove the
characteristic smell of a new machine. When it is clean and dry, insert the accessories in the right places,
according to preferences.
DAILY CLEANING
Do not wash the appliance with direct water jets, as leaks in the electric components
could affect correct operation.
We recommend cleaning the outside of the unit with a damp cloth and following the direction of the stainless
steel's polished finish. It should be dried well and neutral detergents used instead of bleach based and/or
abrasive substances.
Do not use tools that could cause cuts with the subsequent build up of rust.
If there is hardened dirt, use water and soap or neutral detergents, using a plastic or wooden spatula if
necessary.
Clean the inside of the chamber to prevent dirt from building up with neutral detergents that do not contain
bleach and that are not abrasive.
The areas surrounding the appliance should also be cleaned daily, always with soap and water and not with
toxic or bleach-based detergents. Rinse with clean water and dry well.

1.2 GENERAL

WIRING
Before plugging the appliance into the socket, check that the network voltage and frequency correspond with
those indicated on its' nameplate. Also check that the section of the electricity socket is appropriate for the
consumption it is going to withstand.
It is essential that the electrical installation where it is going to be connected has an EARTHING
SOCKET, in addition to the appropriate protection of the magneto-thermal switch and differential
(we recommend 30 mA.)
For your safety, it is prohibited to lengthen this power cable.
A: LEG BODY
B: SCREW:
Clockwise to lower the unit
Anticlockwise to raise the unit
18